OWNER
’
S GUIDE -
햲 TIMER(Orange): When the unit is in reservation on/off timer mode, an orange light will be displayed.
햳 UNIT ON(Green): When the unit is switched on by the remote control or the emergency button,
a green light will be displayed.
햴 FURNACE (user-optional function) EMERGENCY button: can be used when the remote control is lost or inoperative.
When the remote control is lost, damaged or the battery is discharged, the FURNACE EMERGENCY button can
be used to run the unit.
• Press the FURNACE EMERGENCY button when in the off mode condition.
- The unit operates automatically according to the room temperature in the furnace operation.
• The setting conditions of furnace emergency operation are as follows:
- Operation mode: FURNACE - Preset temperature: 73°F
- Fan Speed: Auto (ON/OFF cycle) - Timer mode: Disable
햵 COOL EMERGENCY button: also can be used when the remote control is lost or inoperative. When the remote
control is lost, damaged or the battery is discharged, the COOL EMERGENCY button can be used to run the unit.
• Press the COOL EMERGENCY button when in the off mode condition.
- The unit operates automatically according to the room temperature in the cooling operation.
• The setting conditions of cool emergency operation are as follows:
- Operation mode: COOL - Preset temperature: 75°F
- Fan Speed: AUTO - Timer mode: Disable
4
OPERATING INSTRUCTIONS
If you want to stop the emergency operation, push the EMERGENCY button again or operate
the remote control.
* TEST MODE
: Installer can operate the unit anytime regardless of temperature by pushing Emergency Button
(COOL or FURNACE) more than 5 seconds continuously after installing the unit. (This function is only used by
servicemen to test the unit operation.)
*
Refrigerant Compressor Time Delay
: The Compressor will have a delay in starting of three minutes generally it is
required to begin the cooling cycle.
햶 REMOTE CONTROL SIGNAL RECEIVER
CEILING UNIT DISPLAY
<BOTTOM VIEW>
NOTE
To Next Page
Loading...
