14
• Service access gives access to more tables which are re-
quired for typical service setup. In current software, ser-
vice access is accessible via password 3333 or 1234.
• Factory access (located under Service Login icon) allows
access to critical factory configuration settings and only
authorized users will have access to these menus using
Carrier Smart Service.
From the Home screen, touching the Globe icon displays the
Language and Units Selection screen. See Fig. 16.
Fig. 16 — User Login Screen — Language and Units
Selection
The Lock icon on the Home screen allows access to the pass-
word menu and displays current software version. See Fig. 17.
Fig. 17 — User Login, Login Level = Basic
Main Menu Screen
To access the Main Menu screen, press the Main Menu icon .
Press the icons on the screen to access the appropriate table or
menu. Press the arrows at the bottom right corner, if present, to
navigate through pages of tables. The options shown on the Main
Menu screen depend on the user’s level of access (see the section
User Login Screen on page 13). Figure 18 shows the Main Menu
screen as it appears for the User level of access, Fig. 19 shows the
Main Menu screen for Service level access, and Fig. 20 shows the
Main Menu screen for Factory level access.
Fig. 18 — Main Menu Screen, User Level
Fig. 19 — Main Menu Screen, Service Level
Fig. 20 — Main Menu Screen, Factory Level
Configuration Menu
To access the Configuration menu, press the Configuration icon
on the Main Menu (Service or Factory access level). The
Configuration menu opens. Then press the General Configura-
tion icon on the Configuration menu. See Fig. 21. (Certain
configuration settings are available only for Service or Factory
access levels.) Refer to Appendix A, page 39, for more informa-
tion about Configuration options.
NOTE: The active language is bracketed by arrows.
To Next Page
Loading...
