ALL PANELS MUST BE IN PLACE WHEN RIGGING. DO NOT ATTEMPT TO FORK THESE UNITS IF NO SKID IS SUPPLIED.
CAUTION - NOTICE TO RIGGERS:
NOTES:
1. 1.50 dia. (38.1mm) lifting holes provided for field supplied clevis.
2. Rig with a minimum of 25 ft (7620mm) length chains or cables.
3. If central lifting point is used, it must be a minimum of 13 ft. (3962mm) above the top of the unit.
4. Spreader bars made from steel or double nailed, and notched 2x6's approximately 8 ft. (2438mm) long, must
be placed just above the top of the unit (and stacks) to reduce the risk of damage to the top of the unit and
coils.
5. If overhead rigging is not available, the unit can be moved on rollers or dragged. When unit is moved on
rollers, the unit skid, if equipped, must be removed. To lift the unit, use jacks at the rigging points. Use a
minimum of one roller every 6 ft. (1829mm) to distribute the load. If the unit is to be dragged, lift the unit as
described above, and place unit on a pad. Apply moving force to the pad, not the unit. When in its final
location, raise the unit and remove the pad.
6. Check bill of lading for shipping weight of unit.
30XA080,082
30XA080,082 -CU
30XA090,092
30XA090,092 -CU
30XA100,102
30XA100,102 -CU
30XA110,112
30XA110,112 -CU
30XA120,122
30XA120,122 -CU
30XA140,142
30XA140,142 -CU
30XA160,162
30XA160,162 -CU
30XA180,182
30XA180,182 -CU
30XA200,202
30XA200,202 -CU
30XA501B
30XA501B -C U
7831
8555
10083
10751
10310
10978
10563
11231
10681
11349
13217
14126
13429
14338
13935
15382
14014
15461
3558
4282
3552
3881
4574
4877
4677
4980
4791
5094
4845
5148
5995
6408
6091
6504
6321
6977
6357
7013
1614
1942
8811
9535
11153
11821
11380
12048
11633
12301
11751
12419
14377
15286
14589
15498
15185
16632
15264
16711
4538
5262
3997
4325
5059
5362
5162
5465
5277
5580
5330
5633
6521
6934
6618
7030
6888
7544
6924
7580
2059
2387
16.1
16.1
408.9
408.9
109.03
109.03
2769.3
2769.3
7 0 . 0
7 0 . 0
1 7 7 8
1 7 7 8
4 2 . 7
4 2 . 7
1 0 8 4
1 0 8 4
Fig. 29 — Unit Rigging Label Detail 30XA080-202, 501B
To Next Page
Loading...
