27
NOTES:
1. Unit must have clearances as follows:
Top — Do not restrict
Sides and Ends — 6 ft (1.8 m) from solid surface.
2. Temperature relief devices are located on liquid line and economizer
assemblies and have
1
/
4
-in. flare connection.
3.
3
/
8
-in. NPT vents and drains located in each cooler head at each end of
cooler.
4. Drawing depicts unit with single point power, standard two-pass cooler,
standard SCCR (Sh
ort Circuit Current Rating), and a nominal voltage
range of 380 to 575 v. Refer to the Packaged Chiller Builder program for
other configurations.
5. Dimensions are shown in inches. Dimensions in [ ] are in millimeters.
30XA UNIT A B
180 46.12 [1171] 143.04 [3633]
200 46.15 [1172] 142.97 [3631]
a30-5206
[1555]
[2769]
B
[4502]
[7168]
[914]
[508]
[860]
[162]
A
[1528]
[1782]
[2236]
[3150]
[3013]
[3552]
[2438]
[114]
TOP VIEW
Fig. 11 — 30XA180,200 Air-Cooled Liquid Chiller Dimensions (See Note 4)
To Next Page
Loading...
