40
30RB 302-402 - Total heat reclaim condenser option
Sizes 372 and 402
Power connection
For user control connection
NOTE: Non-contractual drawings.
When designing an installation, refer to the certified
dimensional drawings, available on request.
For the positioning of the fixing points, weight distribu-
tion and centre of gravity coordinates.
ATTENTION: The Victaulic flange sleeves of the condenser
are factory-installed.
3” Victaulic type 75
4” Victaulic type 75
4” Victaulic type 75
3” Victaulic type 75
Clearances required for maintenance and air ow
Clearances recommended for evaporator tube removal
Clearances recommended for heat exchanger removal
Water inlet
Water outlet
Air outlet, do not obstruct
Control box
To Next Page
Loading...