NOTES:
1.
2.
3.
4.
Unit must have clearances as follows:
Top -- Do not restrict.
Sides and End -- 6' from solid surface.
All pumps have drains located at the bottom of
volute for draining.
Temperature relief devices located on suction line,
liquid line and filter drier of each circuit and have 1/4"
flare connection.
Units without a pump package have the same leav-
ing water connection, Y and Z dimensions, (entering
water) and Pump Discharge X dimensions as units
with a pump package.
Dimensions are in mm [inches].
I
SERVICE AREA 1219 2{48 O] FROM EACH SIDE OF IRE UN!I
i4478157D]
COOLER TDDE
, DE_VICE AREA
I
I
PD1 PSl
I
t 18_8Si
2446 09
[96 30]
PIPING ENTRANCE AREA
2?3608
[88 O]]
91615
[36 07]
2728 56
[10742]
SCROLLING _ARQUEE
DISPLAT
FIELD CONTROL WiRI_G
PUMP PACKAGE
E_TERING WATER
RIGGING _iOLE
MOUNTING HOiE
[T 8T]
DE/AiL
SCALE 3:16
AiR FLOW
Z
rl n
crE_
J
I :I _=
i i -
i i ii
/POWER BOX 230V
CONtROL/POWER 80X
380V,_DOVSlSV
19000
[748]
KNOCKOUT TO 5E
USED FOR LOCATING
YIELD POWER WiRInG
Y46 36 _ 356 SO
[970] _1385]
2i9630
[8_ 894}
UNiT _OUNTING
Fig. 5-- 30RBl10 Air-Cooled Chiller Dimensions
To Next Page
Loading...