Remote Controller
GB - 3
ENGLISH
Switching on and normal operation
Operating control mode
By pressing the COOLING
the remote control selects the operating mode
by switching on the LED corresponding to the
selection made (cooling
/ heating
The unit will operate with the
times necessary for the chosen selection.
the remote control will memorise the mode
settings at the time of failure.
ECO control
LED
will come on and the outdoor unit
temperature from the normal condition to the
heating operation.
green LED will go off and the outdoor unit
temperature to the normal condition.
the remote control will memorise the mode
settings at the time of failure.
Diagnostics
The electronic control on the machine continuously monitors its
to the remote control and switching on the alarm LED
in
pre-set sequences.
ON.
Alarm codification
The alarm code generated by a failure is shown to the operator.
The alarm codification is based on the binary two-digit code X1 and
the number corresponding to the second is reached (only for two-
digit codes).
Example:
Alarm code 31 with persistent alarm condition
LED on for 1 second
LED off for 1 second
128H96.indd 3 18-02-2010 16:19:36
To Next Page
Loading...
