11
V. AIR CONDITIONER CONTROLLER (CONT’D.)
V2.3.1 Fan
If the system is in FAN mode, the FAN LED on the Display unit will be lit.
The system will operate as the fan only. The TEMP∆ and TEMP∇ buttons
are not used.
V2.3.2 Cool
If the system is set to COOL mode, the COOL LED on the Display unit will
be lit. The system will operate as the air conditioner. The compressor will
• operate if room temperature is higher than set TEMP +1°
• stop if room temperature is less than set TEMP
However, there is a 3-minute delay protection on the compressor each time it stops
.
V2.4 Temperature setting
Temperature can be set from 18 - 30°C by pressing TEMP∆ or TEMP∇
button. The LCD Display will show the set temperature.
V2.5 Sweep
Press SWEEP button to turn the sweep motor ON or OFF.
To Next Page
Loading...
