13
V. AIR CONDITIONER CONTROLLER (CONT’D.)
While the system is in SLEEP mode:
• Pressing the SLEEP button again cancels the sleep function.
• Pressing the TEMP button will increase the set temperature by
1°C from the last setting.
• And unit is turned off or power failure occurs, the SLEEP
function is cancelled.
V3.1.7 Setting the Clock on the Remote Unit:
• Press button until the Display shows blinking,
• Press button to set the time,
• Press SEND button.
NOTE: If no button is pressed within 10 seconds, LCD display will
return to show setting temperature and no data will be transmitted.
V3.1.8 Auto Start: The air conditioner can be programmed to turn on
at a pre-set time.
• Press button until the display shows blinking ON,
• Press
button to set the timer-on,
• Press SEND button.
To cancel this function
• Press button until the display shows blinking ON,
• Press CANCEL button.
NOTE: If no button is pressed within 10 seconds, LCD display will
return to show setting temperature and no data will be transmitted.
V3.1.9 Auto Stop : The air conditioner can be programmed to turn off at a
pre-set time.
• Press button until the display shows blinking OFF,
• Press
button to set the timer-off,
• Press SEND button.
To Next Page
Loading...
