Carrier Debonair 2 - Advanced Setup - Entry and Display; Entering Advanced Setup Mode

Advanced Setup
10
Select Display operation:
On = Full Display
O = Minimal Display
See page 20
Press the MODE and FAN
buttons at the same time
for 10 seconds to enter
Advanced Setup screens.
NOTE: Each step # is located
at the top right corner of the
display for easy reference.
MODE FAN
Display On
Display O
Select Display operation:
1 = Single Setpoint
2 = Dual Setpoint
See page 24
Note: When Single Setpoint is selected, the heating or cooling
setpoint will always be displayed. To display the room temperature,
press and hold the MODE button for two seconds. The degree icon
will blink when the large number is displaying room temperature
and will remain solid when displaying the heating or cooling
setpoint.
Continued
Setup
Setup
ON
MODE
Press
MODE
Press