NOTE
¤
¤Ł
¤Ø
¤Œ
PROCEDURE
About ON Timer
UNIT OPERAT I O N
O W N E R’S MANUAL - 1 4
TIMER OPERAT I O N
ON Ti m e r
1
ON TIMER button
Press this button.
On start up, time is set at 6:00 A.M..
2
HOUR, MINUTE buttons
Press these buttons to set the start-up time
desired while the ON Timer symbol is flashing.
3
R E S E RV. button
Press this button when pointing the remote control towards
the receiver of the indoor unit.
•A receiving beep is heard.
•TIMER lamp of the indoor unit illuminates.
4
MODE, FAN, FLAP and TEMP. buttons
Set the desired operation mode with these buttons.
•When the ON Timer is set, the unit monitors the room
temperature for 1hour before the set time to make sure
the room condition is reached by the reserve time.
•The actual on time of the unit is earlier than the reserved
on time by 0 to 40 minutes according to the difference
between room temp. and set temp.
•The current time is not indicated during the reservation of ON/OFF Timer.
•When you want to know the current time, press the CLOCK button and you will see the current time
for 5 seconds.
•If you reserve the ON Timer during operation, the unit will operate continuously.
To Next Page
Loading...
