EMERGENCY
TEST
This operation is used for checking after unit installation.
•Press the TEST button.
•Press the TEST button once more after checking to activate the remote control. If there is any input
signal ( remote control signal or EMERGENCY button press ) during test operation, the TEST mode will
change to the input signal mode.
•The setting conditions of the test operation are as follows :
- Operation mode : COOL
- Fan speed : HIGH
- Timer mode : Disable
- Discharge air direction : SWING
Test Operation
O W N E R’S MANUAL - 2 0
UNIT OPERAT I O N
EMERGENCY AND TEST OPERAT I O N
When the remote control is lost, damaged or the battery is discharged, the EMERGENCY button can be used
to run the unit.
•Press the EMERGENCY button at the off mode condition.
- The unit operates automatically according to the room temperature the cooling operation.
•If you want to stop the emergency operation, push the EMERGENCY button again or operate the remote
c o n t r o l .
•The setting conditions of emergency operation are as follows:
- Operation mode : COOL
- Preset temperature : 24℃
- Fan speed : AUTO
- Timer mode : Disable
- Discharge air direction : Horizontal position
Emergency Operation
To Next Page
Loading...
