Carrier i-Vu CCN Router - Replacing the i-Vu CCN Router Battery

Troubleshooting
i-Vu® CCN Router CARRIER CORPORATION ©2021
Installation Guide All rights reserved
9
Other LED's show the status of certain functions.
If this LED is on...
Status is...
Power
The i-Vu® CCN Router has power.
Link
The controller is connected to the Ethernet
LAN
The Ethernet port is transmitting or receiving data
100
The connection speed is 100 Mbps. If LED is not lit, the connection speed is 10
Mbps.
CMnet transmit
The i-Vu® CCN Router is transmitting data over the CMnet
CMnet receive
The i-Vu® CCN Router is receiving data from the CMnet
Archive Valid
The i-Vu® CCN Router's memory backup is valid
Port S1 transmit
The i-Vu® CCN Router is transmitting data from Port S1
Port S1 receive
The i-Vu® CCN Router is receiving data on Port S1
Battery low
The battery is low
To replace the i-Vu® CCN Router's battery
The i-Vu® CCN Router's 10-year Lithium CR123A battery retains the following data for a maximum of 720 hours
during power outages: time, control programs, editable properties, schedules, and trends.
To conserve battery life, you can set the driver to turn off battery backup after a specified number of days and
depend on the archive function to restore data when the power returns.
A low battery is indicated by the Battery low LED or a low battery alarm in the i-Vu® application. You can purchase
replacement batteries from any retailer that sells a CR-123A battery.
1 Verify that the i-Vu® CCN Router's power is on.
2 Using a small flathead screwdriver, pry up each side of the black battery clip until it is free and you can
remove it.
3 Remove the battery from the controller, making note of the battery's polarity.
4 Insert the new battery into the controller, matching the polarity of the battery you removed.
5 Push the black clip back onto the battery until you hear both sides click in place.
6 Download the i-Vu® CCN Router.