Carrier LENEL S2 - Technical Specifications (13.56 MHz;125 kHz); Dual Frequency Operation; Supported Reading Technologies; Power and Current Specifications

3
Operating frequency 125 kHz & 13.56 MHz.
Reading technologies
NFC/BLE, Electromarine EM4200, HID® Proximity, MIFARE CSN 4 byte, MIFARE CSN
7 byte, MIFARE Classic, MIFARE Plus, MIFARE DESFire 0.6, MIFARE DESFire EV1,
MIFARE DESFire EV2**, MIFARE DESFire EV3**, MIFARE Random CSN and iCLASS
CSN 8 byte. Also supports other ISO 14443 A/B* compatible cards.
*Not all ISO14443 B cards have been implemented in the reader, please contact
LenelS2 for more details on current status.
**Application coding must be in accordance with EV1.
MIFARE is a registered trademark of NXP B.V. and is used under license.
Secure Access Module
(SAM):
MIFARE SAM AV2, external SIM card
connection slot.
Communication protocols
Wiegand, Clock/Data, OSDP 1, OSDP 2 (including Secure channel),
RS232 and RS485.
Reading output format 24 to 1024 (excluding parity bits)
Keypad output format Wiegand 4 bit, Wiegand 8 bit (Dorado), Wiegand 26 bit, OSDP ASCII format.
Keypad
12 digit keypad in 4 rows of 3 keys in each row with configurable
backlight in blue color. Control features On/Off/Auto indicators.
Light itensity can be adjusted.
Indicators LED, Green, Red and Yellow. Backlight in blue color. Buzzer.
Power supply 9 to 30 VDC
Current consumption
24 VDC idle mode with heater inactive 60 mA**
12 VDC, idle mode with heater inactive 90 mA**
**Current consumption differs depending on functionality used
and can also be limited in the reader configuration.
Input/Output
4 input for LED- and buzzer control and 2 configurable General Purpose
Input/Output (GPI/O). The GPI/O’s are push/pull type which provides 3.3 VDC
as output when “high” on each respective GPI/O connection pin.
Tamper alarm
Built-in mechanical tamperswitch which allows for
indication break off protection and/or opening of the reader
Operating temperature
-40° to +70°C
When installing readers in environments with extreme heat
(above +50°C) it is recommended to utilize the climate protection
LNL-R50000-WRW which provides additional shading to the reader.
Heater Thermostat controlled embedded heater.
Operating humidity
0 to 95% RHNC
(Relative Humidity No Condensation)
IP rating
IP65
Dimension (W x H x D) 79 x 109 x 25
Configuration method Configuration card, reader tool software or factory configured readers.
Compliances
LenelS2 Readers - 5000 Series
Standard 13.56 MHz/125 kHz
- Technical specifications