48
[1224.0]
48-3/16
[1193.8]
47
[798.5]
31-7/16
[828.7]
32-5/8
[92.1]
3-5/8
DRAIN OUTLET
3/4" [19.1]N.P.T.
X 7/8" [22.2] DEEP
[122.2]
4-13/16
[87.3]
3-7/16
[184.2]
7-1/4
[325.4]
12-13/16
1-3/4 [44.5] DIA. K.O.
POWER ENTRY
[4.8]
3/16
7/8 [22.2] DIA. HOLE
CONTROL ENTRY
"X"
"Z"
"Y"
[325.4]
12-13/16
"A"
[25.4]
1
[252.4]
9-15/16
[547.7]
21-9/16
[252.4]
9-15/16
[87.3]
3-7/16
[404.8]
15-15/16
[27.0]
1-1/16
[403.2]
15-7/8
[166.7]
6-9/16
[250.8]
9-7/8
[549.3]
21-5/8
[250.8]
9-7/8
3-7/16
[87.3]
[476.2]
18-3/4
[325.4]
12-13/16
[133.3]
5-1/4
[514.4]
20-1/4
5-13/16
[149.2]
[649.3]
25-9/16
[69.9]
2-3/4
CENTER OF GRAVITY IN/MMUNIT HEIGHT IN/MM
UNIT WT.
ELECTRICAL
CHARACTERISTICS
UNIT
ZYX"A"
KGLB
414.016-5/16406.416480.118-7/81121.044-1/8167.8370
208/230-3-60
50VT-A30---51
-
50VT500269
4
3
2
1
REV
UNITS VOLTAGE
CORNER WEIGHT LB/KG
"1" "2" "3" "4"
50VT-A30---51
208/230 74.0 33.6 59.2 26.9 88.8 40.3 148.0 67.1
LOUVER PANEL
LOUVER PANEL
LOUVER PANEL
LOUVER PANEL
M
TOP OF UNIT.............................................14 [355. 6
DUCT SIDE OF UNIT........................................2 [50.8 ]
SIDE OPPOSITE DUCTS.....................................14 [355. 6
BOTTOM OF UNIT...........................................0 [0.0]
ELECTRICAL PANEL........................................36 [914. 4
M
BETWEEN UNITS, POWER ENTRY SIDE........................42 [1066. 8
UNIT AND UNGROUNDED SURFACES, POWER ENTRY SIDE.........36 [914.0 ]
UNIT AND BLOCK OR CONCRETE WALLS AND OTHER
GROUNDED SURFACES, POWER ENTRY SIDE....................42 [1066. 8
[M
POWER ENTRY SIDE........................................42 [1066
(EXCEPT FOR NEC REQUIREMENTS)
UNIT TOP................................................48 [1219
SIDE OPPOSITE DUCTS.....................................36 [914. 0
DUCT PANEL..............................................12 [304. 8
ECONOMIZER HOOD SIDE....................................55 [1397
*MINIMUM DISTANCES:IF UNIT IS PLACED LESS THAN 12 [304.8] FROM WA
SYSTEM,THEN SYSTEM PERFORMANCE MAYBE COMPROMI S
**CLEARANCE DISTANCE TO BE MEASURED FROM LEFT SIDE OF UNIT.
DIMENSIONS IN [] ARE IN MILLIMET E
CG
FRONT VIEW
COMPRESSOR
PANEL
BLOWER
PANEL
ELECTRICAL
ACCESS PANEL
OUTDOOR COIL
OPTIONAL
RETURN
AIR
OPENING
OPTIONAL
SUPPLY
AIR
OPENING
OUTDOOR COIL
RETURN
SUPPLY
CG
INDOOR COIL
TOP VIEW
RIGHT SIDE VIEW
LEFT SIDE VIEW
SUPPLY
DUCT
OPENING
RETURN
DUCT
OPENING
REAR VIEW
REQUIRED CLEARANCES TO COMBUSTIBLE MATL
NEC. REQUIRED CLEARANCES
REQUIRED CLEARANCE FOR OPERATION AND SERVICING
A10212
Fig. 48 -- 50VT --A 30 3 Phase with Economizer
50VT--A
To Next Page
Loading...
Need help?
General