Carrier RG10B10/BGEF - 3. HOW TO USE BASIC FUNCTIONS; 3.1 Basic Operations

3. HOW TO USE BASIC FUNCTIONS
3.1 BASIC OPERATIONS
AUTO
Mode
Select AUTO mode Set your desired temperature
NOTE:
1. In AUTO mode for heat pump system, the air conditioner can automatically choose the mode of
Cool, Heat or Fan by sensing the difference between the actual room temperature and setting
temperature.
2. In AUTO mode for cooling only system, the air conditioner can automatically choose the mode of
Cool or Fan by sensing the difference between the actual room temperature and setting temperature.
3. In AUTO mode, fan speed can not be set.
Mode
Turn on the air conditioner
COOL
or
HEAT
Mode
Select COOL/HEAT mode
Set the temperature
Turn on the air conditioner
Set the fan speed
DRY
Mode
Select DRY mode Set the temperature
NOTE:
In DRY mode, fan speed can not be set since it has already been automatically controlled.
Turn on the air conditioner
FAN
Mode
Select FAN mode
Turn on the air conditioner
Set the fan speed
Before operation, please ensure the unit is plugged in and power is available.
ATTENTION
Mode
Mode
Mode
NOTE:
1. Above illustration shows all the features. For actual model, only the relevant parts are shown.
2. Buttons design might be slightly different from the actual one.
06
05
2.2 BUTTONS
MODEL:RG10B2(U2)/BGEF
RG10B10(U2)/BGEF(20-28 C/68-82 F)
RG10B2(U2)/BGCEF(
( Cooling only models, AUTO mode and
HEAT mode are not available
)
On/Off
Press to start operation.
Press again to stop.
Mode
Press the mode button to
switch the mode in turn.
ECO Sleep
My Mode
Press to memorize or resume
your favorite pre-settings.
LED
LOCK
Fan Speed
Press to select the desired fan speed:
Temperature UP
Increases temperature in
1 C /1 F increments.
Max. Temp. is 30 C/86 F .
Press to turn on/off the LED
display. Pressing 5 more
seconds to alternate the indoor
display between setting
temperature and room
temperature(Model dependent).
Press to enter Sleep Mode.
Decreases temperature in 1 C/1 F
increments. Min. Temp. is
16 C/60 F.
Temperature Down
Swing
ECO
Sleep
My
Mode
NOTE: HEAT mode is not supported
by the cooling only appliance.
SET
Scrolls through operation
functions as follows:
Fresh( ) Follow Me( )
AP mode( ) Fresh....
The selected symbol will flash on
the display area, press the OK
button to confirm.



OK
Used to confirm the selected
functions.
TIMER
Set timer to turn unit on or off.
Clean
Used to start/stop the Self Clean
or Active Clean function.
(Model dependent).
Press together Clean button and
Turbo button at the same time more
than 5 seconds to activate Lock
function.
Turbo
Enables unit to reach preset
temperature in shortest possible time.
NOTE: Press together &
buttons at the same time for 3 seconds
will alternate the temperature display
between the °C & °F.
LOW
MED
HIGH
AUTO
Starts and stops the horizontal louver
movement. Hold down for 2 seconds
to initiate vertical louver auto swing
feature(some units).