121
VFD INFORMATION DISPLAY TABLE
The VFD information display table provides information on the
supply fan VFD and exhaust fan VFD. See Table 100.
MODE TRIP HELPER
The Mode Trip Helper table provides information on the unit
modes and when the modes start and stop. See Table 101. This in-
formation can be used to help determine why the unit is in the cur-
rent mode.
CCN/LINKAGE DISPLAY TABLE
The CCN/Linkage display table provides information on unit link-
age. See Table 102.
COMPRESSOR RUN HOURS DISPLAY TABLE
The Compressor Run Hours Display Table displays the number of
run time hours for each compressor. See Table 103.
COMPRESSOR STARTS DISPLAY TABLE
The Compressor Starts Display Table displays the number of starts
for each compressor. See Table 104.
SOFTWARE VERSION NUMBERS DISPLAY TABLE
The Software Version Numbers Display Table displays the soft-
ware version numbers of the unit boards and devices. See Table
105.
Table 100 — VFD Information Display Table
Table 101 — Mode Trip Helper Display Table
Table 102 — CCN/Linkage Display Table
ITEM EXPANSION RANGE UNITS CCN POINT WRITE STATUS
VFDS VFD INFORMATION
S.VFD SUPPLY FAN VFD (VFD 1)
SPD VFD1 Actual Speed % VFD1_SPD
rpm VFD1 Actual Motor rpm VFD1rpm
FREQ VFD1 Actual Motor Freq VFD1FREQ
AMPS VFD1 Actual Motor Amps VFD1AMPS
TORQ VFD1 Actual Motor Torque VFD1TORQ
PWR VFD1 Actual Motor Power VFD1PWR
VDC VFD1 DC Bus Voltage VFD1VDC
V.OUT VFD1 Output Voltage VFD1VOUT
TEMP VFD1 Transistor Temp (C) VFD1TEMP
RUN.T VFD1 Cumulative Run Time VFD1RUNT
KWH VFD1 Cumulative kWh VFD1KWH
LFC VFD1 Last Fault Code VFD1LFC
E.VFD EXHAUST FAN VFD (VFD 2)
SPD VFD2 Actual Speed % VFD2_SPD
rpm VFD2 Actual Motor rpm VFD2rpm
FREQ VFD2 Actual Motor Freq VFD2FREQ
AMPS VFD2 Actual Motor Amps VFD2AMPS
TORQ VFD2 Actual Motor Torque VFD2TORQ
PWR VFD2 Actual Motor Power VFD2PWR
VDC VFD2 DC Bus Voltage VFD2VDC
V.OUT VFD2 Output Voltage VFD2VOUT
TEMP VFD2 Transistor Temp (C) VFD2TEMP
RUN.T VFD2 Cumulative Run Time VFD2RUNT
KWH VFD2 Cumulative kWh VFD2KWH
LFC VFD2 Last Fault Code VFD2LFC
ITEM EXPANSION RANGE UNITS CCN POINT WRITE STATUS
TRIP MODE TRIP HELPER
UN.C.S Unoccup. Cool Mode Start UCCLSTRT
UN.C.E Unoccup. Cool Mode End UCCL_END
OC.C.S Occupied Cool Mode Start OCCLSTRT
OC.C.E Occupied Cool Mode End OCCL_END
TEMP Ctl.Temp RAT,SPT or Zone CTRLTEMP
OC.H.E Occupied Heat Mode End OCHT_END
OC.H.S Occupied Heat Mode Start OCHTSTRT
UN.H.E Unoccup. Heat Mode End UCHT_END
UN.H.S Unoccup. Heat Mode Start UCHTSTRT
HVAC ascii string spelling out the hvac modes string
ITEM EXPANSION RANGE UNITS CCN POINT DEFAULT
LINK CCN - LINKAGE
MODE Linkage Active - CCN ON/OFF MODELINK
L.Z.T Linkage Zone Control Tmp dF LZT
L.C.SP Linkage Curr. Cool Setpt dF LCSP
L.H.SP Linkage Curr. Heat Setpt dF LHSP