216
STAGEGAS
Heating Mode………..: ascii text strings
Requested Heat Stage HT_STAGE
Heating Control Point HEATCPNT
Staged Heat LAT Sum dF LAT_SGAS
Staged Heat LAT 1 dF LAT1SGAS
Staged Heat LAT 2 dF LAT2SGAS
Staged Heat LAT 3 dF LAT3SGAS
Staged Gas Limit Sw.Temp dF LIMSWTMP
Heat PID Timer sec HTSGTIMR
Staged Heat Capacity Calc % HTSGCALC
Current Running Capacity % HTSG_CAP
Proportional Cap. Change HTSG_P
Derivative Cap. Change HTSG_D
Maximum Heat Stages HTMAXSTG
Hi Limit Switch Tmp Mode LIMTMODE
LAT Cutoff Mode LATCMODE
Capacity Clamp Mode CAPMODE
STRTHOUR
Compressor A1 Run Hours hours HR_A1 config
Compressor A2 Run Hours hours HR_A2 config
Compressor A3 Run Hours hours HR_A3 config
Compressor B1 Run Hours hours HR_B1 config
Compressor B2 Run Hours hours HR_B2 config
Compressor B3 Run Hours hours HR_B3 config
Compressor A1 Starts CY_A1 config
Compressor A2 Starts CY_A2 config
Compressor A3 Starts CY_A3 config
Compressor B1 Starts CY_B1 config
Compressor B2 Starts CY_B2 config
Compressor B3 Starts CY_B3 config
SUMZ
Cooling Control Point dF COOLCPNT
Mixed Air Temperature dF MAT
Evaporator Discharge Tmp dF EDT
Return Air Temperature dF RAT forcible
Outside Air Temperature dF OAT forcible
Economizer Act.Curr.Pos. % ECONOPOS
Economzr 2 Act.Curr.Pos. % ECON2POS
Capacity Threshold Adjst Z_GAIN config
Capacity Load Factor SMZ
Next Stage EDT Decrease ADDRISE
Next Stage EDT Increase SUBRISE
Rise Per Percent Capacity RISE_PCT
Cap Deadband Subtracting Y_MINUS
Cap Deadband Adding Y_PLUS
Cap Threshold Subtracting Z_MINUS
Cap Threshold Adding Z_PLUS
High Temp Cap Override On/Off HI_TEMP
Low Temp Cap Override On/Off LOW_TEMP
Pull Down Cap Override On/Off PULLDOWN
Slow Change Cap Override On/Off SLO_CHNG
SYSTEM
Reset All Current Alarms Yes/No ALRESET config
Reset Alarm History Yes/No ALHISCLR config
Reset the Device Yes/No RESETDEV config
Local Machine Disable Yes/No UNITSTOP config
Soft Stop Request Yes/No SOFTSTOP forcible
Emergency Stop Enable/Disable EMSTOP forcible
CEM AN4 10K temp J5, 7-8 CEM10K1 forcible
CEM AN5 10K temp J5, 9-10 CEM10K2 forcible
CEM AN6 10K temp J5, 11-12 CEM10K3 forcible
CEM AN1 10K temp J5, 1-2 CEM10K4 forcible
CEM AN4 4-20 ma J5, 7-8 CEM4201 forcible
CEM AN5 4-20 ma J5, 9-10 CEM4202 forcible
CEM AN6 4-20 ma J5, 11-12 CEM4203 forcible
CEM AN1 4-20 ma J5, 1-2 CEM4204 forcible
APPENDIX B — CCN TABLES (CONT)
Table P — MAINTENANCE DISPLAY TABLES (cont)
TABLE DISPLAY NAME RANGE UNITS POINT NAME WRITE STATUS
To Next Page
Loading...
