Carrier Weathermaster 48P2030-100 - Page 186

186
APPENDIX A — LOCAL DISPLAY TABLES
Table H — MODE — CONFIGURATION
ITEM EXPANSION RANGE UNITS CCN POINT DEFAULT PAGE NO.
UNIT UNIT CONFIGURATION
C.TYP Machine Control Type 1 to 4 (multi-text strings) CTRLTYPE 4 33, 41, 44-47, 49-52, 56, 60-
62, 80, 88, 90, 99
SIZE Unit Size (30-100) 30 to 100 UNITSIZE 30 44, 45, 46, 51
FN.MD Fan Mode (0=Auto, 1=Cont) 0 to 1 (multi-text strings) FAN_MODE 1 33, 44, 45
RM.CF Remote Switch Config 0 to 3 (multi-text strings) RMTINCFG 0 39, 44, 45, 99
CEM CEM Module Installed Yes/No CEM_BRD No 44, 45, 118
TCS.C Temp.Cmp.Strt.Cool Factr 0 to 60 min TCSTCOOL 0 44, 45, 93
TCS.H Temp.Cmp.Strt.Heat Factr 0 to 60 min TCSTHEAT 0 44, 45, 93
SFS.S Fan Fail Shuts Down Unit Yes/No SFS_SHUT No 44, 45, 72, 127
SFS.M Fan Stat Monitoring Type 0 to 2 (multi-text strings) SFS_MON 0 44, 45, 72, 127
VAV.S VAV Unocc.Fan Retry Time 0 to 720 min SAMPMINS 50 44, 45
50.HZ 50 Hertz Unit ? Yes/No UNIT_HZ No 44, 45, 46, 51
MAT.S MAT Calc Config 0 to 2 (multi-text strings) MAT_SEL 1 44, 45, 54
MAT.R Reset MAT Table Entries? Yes/No MATRESET No 44, 45, 54
MAT.D MAT Outside Air Default 0 -100 % MATOAPOS 20 44, 45
ALTI Altitude……..in feet: 0 to 60000 ALTITUDE 0 44, 45
DLAY Startup Delay Time 0 -900 secs DELAY 0 44, 46
AUX.R Auxiliary Relay Config 0 to 3 (multi-text strings) AUXRELAY 0 44, 46
SENS INPUT SENSOR CONFIG
SENSSPT.S Space Temp Sensor Enable/Disable SPTSENS Disable 33, 44, 46
SENSSP.O.S Space Temp Offset Sensor Enable/Disable SPTOSENS Disable 44, 46, 99
SENSSP.O.R Space Temp Offset Range 1 to 10 SPTO_RNG 5 44, 46, 99
SENSSRH.S Space Air RH Sensor Enable/Disable SPRHSENS Disable 44, 45, 46, 88
SENSRRH.S Return Air RH Sensor Enable/Disable RARHSENS Disable 44, 45, 46, 77, 88, 95, 126
SENSFLT.S Filter Stat.Sw.Enabled ? Enable/Disable FLTS_ENA Disable 44, 46, 72
COOL COOLING CONFIGURATION
A1.EN Enable Compressor A1 Enable/Disable CMPA1ENA Enable 47, 48
A2.EN Enable Compressor A2 Enable/Disable CMPA2ENA Enable 47, 48
A3.EN
Enable Compressor A3 Enable/Disable CMPA3ENA Enable 47, 48
B1.EN Enable Compressor B1 Enable/Disable CMPB1ENA Enable 47, 48
B2.EN Enable Compressor B2 Enable/Disable CMPB2ENA Enable 47, 48
B3.EN Enable Compressor B3 Enable/Disable CMPB3ENA Enable 47, 48
CS.A1 CSB A1 Feedback Alarm Enable/Disable CSB_A1EN Enable 48
CS.A2 CSB A2 Feedback Alarm Enable/Disable CSB_A2EN Enable 48
CS.A3 CSB A3 Feedback Alarm Enable/Disable CSB_A3EN Enable 48
CS.B1 CSB B1 Feedback Alarm Enable/Disable CSB_B1EN Enable 48
CS.B2 CSB B2 Feedback Alarm Enable/Disable CSB_B2EN Enable 48
CS.B3 CSB B3 Feedback Alarm Enable/Disable CSB_B3EN Enable 48
Z.GN Capacity Threshold Adjst 0.1 to 10.0 Z_GAIN 1 48, 52, 53, 54, 116
MC.LO Compressor Lockout Temp -25 to 55 dF OATLCOMP 40 48, 54
LLAG Lead/Lag Configuration 0, 1, 2 LEAD_LAG 0 48
M.M. Motor Master Control ? Yes/No MOTRMAST No 48, 49, 56
 SCT.H Maximum Condenser Temp 100 to 150 dF SCT_MAX 115 48, 49, 56
 SCT.L Minimum Condenser Temp 40 to 90 dF SCT_MIN 72 48, 49, 56
 DG.A1 A1 is Digital Scroll Yes/No DIGCMPA1 No 48, 49
 MC.A1 A1 Min Digital Capacity 10 to 100 % MINCAPA1 50 48, 49
 DS.AP Dig Scroll Adjust Delta 0 -100 % DSADJPCT 100 48, 49
 DS.AD Dig Scroll Adjust Delay 15 to 60 sec DSADJDLY 20 48, 49
 DS.RP Dig Scroll Reduce Delta 0 -100 % DSREDPCT 6 48, 49
 DS.RD Dig Scroll Reduce Delay 15 to 60 sec DSREDDLY 30 48, 49
 DS.RO Dig Scroll Reduction OAT 70-120 dF DSREDOAT 95 48, 49
 DS.MO Dig Scroll Max Only OAT 70-120 dF DSMAXOAT 105 48, 49
 MLV Min Load Valve Enable Enable/Disable MLV_ENAB Disable 48, 49, 99
 H.SST Hi SST Alert Delay Time 5 to 30 min HSSTTIME 10 48, 49, 124
 RR.VF Rev Rotation Verified? Yes/No REVR_VER No 48, 49, 124
 CS.HP Use CSBs for HPS Detect? Yes/No CSBHPDET Yes 48, 49
EDT.R EVAP.DISCHRGE TEMP RESET
RS.CF EDT Reset Configuration 0 to 3 (multi-text strings) EDRSTCFG 2 33, 39, 47, 122
RTIO Reset Ratio 0 to 10 RTIO 3 33, 47
LIMT Reset Limit 0 to 20 deltaF LIMT 10 33, 47
RES.S EDT 4-20 ma Reset Input Enable/Disable EDTRSENS Disable 33, 45, 47
HEAT HEATING CONFIGURATION
HT.CF
Heating Control Type 0 to 5 HEATTYPE 0 60, 61, 62, 63, 64, 65, 68, 69,
89, 90
HT.SP Heating Supply Air Setpt 80 to 120 dF SASPHEAT 85 60
OC.EN Occupied Heating Enabled Yes/No HTOCCENA No 60, 61
LAT.M MBB Sensor Heat Relocate Yes/No HTLATMON No 60, 68
SG.CF STAGED HEAT CONFIGS
SG.CFHT.ST Staged Heat Type 0 to 8 HTSTGTYP 0 60, 63, 64, 65, 66, 67
SG.CFCAP.M Max Cap Change per Cycle 5 to 45 HTCAPMAX 45 60, 63, 64
SG.CFM.R.DB St.Ht DB min.dF/PID Rate 0 to 5 HT_MR_DB 0.5 60, 63, 64
SG.CFS.G.DB St.Heat Temp. Dead Band 0 to 5 ^F HT_SG_DB 2 60, 63, 64
SG.CFRISE Heat Rise dF/sec Clamp 0.05 to 0.2 HTSGRISE 0.06 60, 63, 64, 67