Carson X4 Quadcopter 550 - Lipo Battery Charging; Ready to Start

To Next Page

To Previous Page

GB // 26

LIPO BATTERY CHARGING

The quadcopter is equipped with a LiPo

battery

7.4 V 1-cell 1200 mAh LiPo battery.

Use only the charger supplied to charge the LiPo battery.

Charging:

1. Connect the plug-in wall charger to the socket. (Status LED

turns green)

2. Now connect the battery to the charger. (Status LED turns red

– battery is charging)

3. The battery is fully charged when the status LED turns green

again.

READY TO START

Now we‘re good to go! But before liftoff, make sure that you have read this manual through completely.

Now move the throttle lever completely up and then back down.

Nowthequadcopterisreadytolaunch.

Nowconnectthebatterytothequadcopter.

The LEDs on the copter start to flash.

Push the throttle lever fully down and then switch on the transmitter.

ON/OFF