Need help?Do you have a question about the CARVIN STARJET and is the answer not in the manual?
General| Pan Range | 540° |
|---|---|
| Tilt Range | 270° |
| Light Source | LED |
| Control | DMX512 |
| Weight | 15.4 kg |
The StarJet Pool Water Jet is designed to fit Carvin's Diamond and Gold Series pools.
Features adjustable light color and intensity when installed with Carvin accessories.
Choose the desired locations for installing the StarJet on the pool edge.
Remove the protective cap from the top ledge cover for access.
Remove the screw securing the top ledge cover in place.
Detach the top ledge cover from the pool edge.
Pass the water tubing beneath the pool ledge to the furthest StarJet location.
Route tubing through designated pass-throughs around the pool to the manifold.
Prepare a 30 cm section of tubing and route it through the ledge cover.
Screw the StarJet top ledge cover adaptor to the front top ledge cover.
Connect the water tubing to the 45° fitting under the StarJet tank.
Connect StarJet light inline with existing StarGlow lights if applicable.
Conceal cables and tubing neatly under the StarJet shell.
Screw the StarJet shell assembly to the StarJet top ledge cover.
Install the protective screw cap onto the StarJet assembly.
Connect the 12-inch tubing section to the main tubing run.
Connect each end of tubing to the Carvin 4-way Manifold.
Recommendation to split return water 50/50 for optimal StarJet usage.
Use flow valves and 3-way valve to regulate jet distance and pressure.
Addresses poor water jet performance due to debris or kinks in the system.
Guidance for issues where the StarJet's LED light is not functioning.
Instructions to remove the StarJet body and unscrew the reservoir for cleaning.
Steps to unscrew the tank nut, washer, and gasket for cleaning.
Instructions to pull out and clean the diffusers, noting their order.
Rinse the diffusers and tank, then reassemble following the reverse steps.
Disconnect the 30 cm (12 inch) tubing from the StarJet unit.
Disconnect all tubing from the manifold and open valves to drain water.
Remove the StarJet screw cap using a flat screwdriver.
Unscrew the StarJet shell from the top ledge adaptor.
Disconnect the electric connection from lights or starter kit.
Remove and store all StarJet units facing downwards.
Ensure the 3-way valve and flow valves are in open position for winter.
Details dimensions, operating/storage temperatures, voltage, current, power, and tubing compatibility.
Guidance for contacting authorized retailers, distributors, and technical support.
Covers warranty period, coverage, exclusions, and claims process.
Information on obtaining replacement parts from authorized retailers.
To Next Page
