CAS 25AC - Operations; When You Know the Number of the Samples; When You Know the Unit Weight of a Sample

11
10
OPERATIONS
1. When You Know the Number of the Samples
When you know the number of the samples, you can use this method.
Make sure that ZERO lamp is on.
Place the samples on
the platter.
Enter the number of the
samples with the numeric
keys.
Press the PCS key, then
the unit weight display will
show the unit weight of
sample.
Remove the samples and press the C key.
NOTE: If the unit weight display shows "-----", remove the samples and press
the C key. In this case, it is impossible to know the unit weight.
Insert load cell connector into the load cell terminal.
Plug the scale into an AC socket and make sure that the socket's power is
within the scale's operating range.
Turn ON the power switch.
Press ON/OFF key on the keyboard.
The scale count up to 9's and you will hear a beep.
PCS U.W. TARE ZERO
PCS U.W. TARE ZERO
PCS U.W. TARE ZERO
2. When You Know the Unit Weight of a Sample
When you know the unit weight of a sample, you can use this method.
Make sure that ZERO lamp is on.
PCS U.W. TARE ZERO PCS U.W. TARE ZERO
Place the samples on
the platter.
Enter the unit weight of a
sample.
Press the U.W. key, then
the number display will show
the number of the samples.