15
14
2. BATTERY OPERATING TIME
The discharge time is dependent on the charging method and
power source.
In generally, if you use the battery continuously, the discharge
time is as follows.
with E.L. 16~22hours.
without E.L. 37~50hours.
Caused by repeated use, the discharge time can be decreased.
If the scale is not used for long time after charging the battery,
the discharge time is decreased. To restore the discharge time,
repeat the procedure of charge and discharge(if battery is
discharged the "BAT" lamp on the LCD will be displayed) for
2 or 3 times.
3. LOW BATTERY("BAT.") SIGNAL
To protect over-discharge of BATTERY, "BAT" LAMP is lit when
battery has to be charged.
A scale turns power off automatically an fixed period after "BAT"
is ON.
1. REMOTE CONTROLLER OPERATION
"ON/OFF" key : Power ON/OFF.
"ZERO" key : Make the scale stable to "0" while the zero point is drifted.
"TARE" key : Store the tare weight.
"kg/lb" key : Select kg or lb mode.
"HOLD" key : Capture and display weight.
OPERATION LAMP : Blinks once when keys are pressed.
2. REPLACING BATTERY IN REMOTE CONTROLLER
BATTERY SPEC.
VOLTAGE : 1.5V 2
SIZE : AA SIZE(14.5 50.5m/m)
BATTERY
NOTE ON REPLACING BATTERIES.
Place batteries in correct polarity(+)(-)direction.
Do not use new batteries with the used.
REMOTE CONTROL
ASSEMBLE AND DISASSEMBLY
DEVICE PIN
HOOK
LOAD PIN
To Next Page
Loading...
Need help?
General
