Casa Systems C100G - Channel Bonding and Partial Service; Channel Bonding Confirmation; Partial Service Best Practices; CCAP;CM Diagnostics

21
Casa commands
ARRIS commands
Channel Bonding
confirm Bonding
Note: channel bonding is enabled by
default in any intersection of a
DOCSIS MAC domain and a service
group.
show cable modem
show cable modem bonding
show downstream channel set
show upstream channel set
Note: channel bonding must be explicitly
enabled with the commands below.
configure interface cable-mac 1
cable dynamic-rcc
configure interface cable-mac 1
cable downstream-bonding-group
dynamic enable
configure interface cable-
upstream 1/0/0 cable supervision
12/0/0-3
configure interface cable-
upstream 1/0/1 cable supervision
12/0/0-3
configure interface cable-
upstream 1/0/2 cable supervision
12/0/0-3
configure interface cable-
upstream 1/0/3 cable supervision
12/0/0-3
show cable bonding-group-status
show cable channel-sets
Partial Service
configure Partial Service
best practices
cable cm-status-report event-list
1,4,7,8
show cable modem cm-status log
cable partial-service continue-
ranging
configure cable global recover-US-
impaired-ack
CCAP/CM Diagnostics
display statistics for RFI
interfaces
show interface qam brief
show interface qam stat
show interface upstream brief
show interface upstream stat
show interface cable
show interface cable-mac [<mac>] bit-
rate
show interface cable-upstream