Need help?Do you have a question about the Casa Systems C100G and is the answer not in the manual?
General| Category | DOCSIS 3.1 |
|---|---|
| DOCSIS | 3.1 |
| Humidity | 5% to 95% non-condensing |
| LAN Ports | 4 x 1Gbps |
| Throughput | Up to 1 Gbps upstream |
| Management | Web GUI |
| Operating Temperature | 0°C to 40°C |
Commands for managing CPU redundancy status and failover.
Commands for managing I/O module redundancy status and failover.
Commands for copying, showing, and transferring configuration files.
Commands for managing software versions and patches.
Commands to configure LACP trunking.
Command to view LACP summary information.
Commands to configure VLANs as network trunks.
Commands to configure loopback interface IP addresses.
Commands to configure DHCP relay for CMs and CPEs.
Commands for configuring OSPFv2 routing instances.
Commands for configuring OSPFv3 routing parameters.
Commands to verify Bidirectional Forwarding Detection status.
Commands to verify OSPFv4 interface and neighbor status.
Commands to verify OSPFv3 status and database.
Commands for configuring OSPF ASBR with RIP and prefix lists.
Commands to define VRF tables with route distinguishershers.
Commands to associate networks with a VRF.
Commands to enable MPLS and LDP on trunk interfaces.
Commands to establish LDP peering with neighbor routers.
Commands to verify BGP, LDP, and MPLS configurations.
Commands for configuring EoMPLS instances and assigning cable modems.
Commands to establish VPLS names and identifiers.
Commands to configure BGP as the signaling protocol for VPLS.
Commands to add BPI-enabled cable modems to VPLS.
Commands for managing system configuration messages and SSH keys.
Commands to set system time and configure NTP servers.
Commands for configuring DNS servers and managing local users.
Commands to create custom CLI aliases.
Commands for configuring local logging and Syslog.
Commands for configuring SNMP communities and versions.
Commands for configuring SNMP traps.
Commands to create SNMP communities with MIB tree access restrictions.
Commands for configuring PIM traps.
Commands for configuring TACACS+ authentication and accounting.
Commands to create, apply, and remove ACLs.
Commands to create and apply global access classes.
Commands to diagnose NSI interface issues.
Commands to diagnose memory issues and DHCP.
Commands to diagnose HA and trunking issues.
Commands for configuring downstream transmitters using Annex B.
Commands for configuring upstream receivers.
Commands for configuring downstream transmitters using Annex A.
Detailed commands for configuring Annex A upstream receivers.
Commands for configuring DOCSIS MAC interfaces for Annex B.
Commands for configuring DOCSIS MAC interfaces for Annex A.
Commands for enabling DOCSIS security features.
Commands for configuring Static MAP advance and interleave level.
Commands for enabling pre-equalization and configuring modulation profiles.
Detailed parameters for configuring modulation profiles.
Commands for configuring service groups for load balancing.
Commands to enable and configure load balancing.
Notes on channel bonding enablement.
Best practices for partial service configuration.
Commands to display statistics for RFI interfaces.
Commands for interface diagnostics and enabling/disabling debugging.
Commands to display various cable modem statuses and information.
Commands for performing remote queries on cable modems.
Command to issue DOCSIS pings.
Commands to configure cable flap list parameters.
To Next Page