Step 4-Handlebar post assembly
1. Please remove the M8x16 Allen bolt (E-2), semicircle washers (E-1) and flat washers (E-3)
from the main frame (G-9).
2. Take the handlebar post cover (G-24) and pass it through the handlebar post (H-2).
3. Hold the handlebar post (H-2) and connect the lower console cable (G-20) to the upper console
cable (H-1).
4. Slide the handlebar post (H-2) into the main frame (G-9), then fix it with four sets of Allen bolts
(E-2), semicircle washers (E-1) and flat washers (E-3)
.
Remarks: Do not screw one set of the M8X16 Allen bolts and flat washers too firmly at a time. It
is better to fix the four sets firmly at the same time because it helps you to change angles and
make adjustments easily.
E-2 M8x16L
E-1 Ø8x2t
x2
x4
N-6 Allen key
E-3 Ø8x2t
x2
4
To Next Page
Loading...
