Cascade F Series - Page 7

6028021 Rev. 1 5
NSTALLATION
I
6
Install pushbutton switch for
SWING function
A Mount the pushbutton switch on the ROTATE
function control lever using double-sided
foam tape. Apply heat-shrink tubing over
control lever and switch. Use cable ties as
necessary to secure wiring.
B With Power Relay – Connect the wiring
harness and cables as shown in B below.
C Direct connection – Connect the wiring
harness and cables as shown in C below.
CONTROL LEVER with PUSHBUTTON SWITCH
AC0585.ill
AC0235.ill
Solenoid
Coil
Power Supply
Wire Harness
3N2
Control
Valve
A
Solenoid
Cable
Switch
Cable
Fuse
Pushbutton switch on
ROTATE control lever
AC0236.ill
NOTE: Remove
tubing around
button as desired
Heat-Shrink Tubing
ROTATE Control Lever
Pushbutton Switch
(for SWING function)
Cable Ties
IMPORTANT: Pushbutton should be installed
on ROTATE function lever (ITA Standards).
When pushbutton is depressed, control lever
should activate SWING function.
AC0351.ill
4
1
3
2
B
Fuse
Normally-Open
Pushbutton
Truck
Fuse Block
(Switched)
Normally-Closed
Solenoid Cartridge Valve
Relay
Truck
Fuse Block
(Unswitched)
Relay
AC0586.ill
ELECTRICAL HOOKUP WITH RELAY (recommended)
C
DIRECT CONNECTION
Foam Tape
Fuse
Normally-Open
Pushbutton
CAUTION: Consult OEM for proper positive
(+) power source connection.
Ground
Truck
Fuse Block
(Switched)
Ground
12-96V
Coil
Diode
Switched
Unswitched
Ground
12-96V
Coil
Dropping Resistor
(36-96V systems only)