Cascade F Series - Page 6

4 6028021 Rev. 1
NSTALLATION
I
Install Rotate/Swing circuit hoses
Measure and assemble hoses (user-supplied)
for the rotate/swing circuit. Install hoses using
straight fittings wherever possible. Use hose
clamps as necessary to secure hoses and
prevent chafing.
The first set of rotate/swing function hoses run
from truck auxiliary valve ports to the control
valve ROTATE IN ports.
The second set of rotate function hoses run from
control valve ROTATE OUT ports to a LH or RH
2-Port hose reel or internal reeving.
5
RC1304.ill
RH 2-Port
Hose Reel
Truck Auxiliary
Valve Ports
ROTATE/SWING
Hoses
CL
CL CCW CW
TANK
ROTATE
CCW CW
CL
CL CCW CW
TANK
ROTATE
CCW CW
OPEN
CLAMP
ROTATE CCW/
SWING EXTEND
ROTATE CW/
SWING RETRACT
Revolving Connection
End Block
AC0771.ill
Hose Reels
OR
Internal Reeving
3N2
Control
Valve
Truck
Auxiliary
Valve
(ROTATE/SWING)
Truck
Auxiliary
Valve
(CLAMP)
Truck
Pump
Tank Return
Line Adapter
Truck
Relief
Truck
Tank
Solenoid
Coil
(capped -
top or bottom)
'Tee' configuration
CLAMP
ROTATE
ROTATE/SWING
Hoses
CLAMP
Hoses
NOTE: Revolving Connection end block may
have either LH or RH porting for the CLAMP
and ROTATE/SWING circuits (LH CLAMP
circuit shown below).