INTRODUCTION
Safety rules - Personal safety
AXIAL-FLOW 5130, AXIAL-FLOW 6130, AXIAL-FLOW 7130
Carefully study these pr ecautions, and those included in the external attachment operators
manual, and insist that they be follow ed by those working with and for you.
1. Thoroughlyread and understand this manual and the attachment Operator ’s Manual bef ore operating this or any
other equipment.
2. Be sure all people and pets are clear of the machine before starting. Sound the horn, if equipped, three times
bef ore starting engine.
3. Only the operator should be on the machine when in operation. Never allow anyone to climb on to the machine
while it is in motion. If the machine is equipped with an Instructors Seat, this must only be used for training
purposes. Passengers must not be allowed to use the Instructors Seat.
4. Keep all shields in place. Never work around the machine or any of the attachments while wearing loose clothing
that might catch on moving parts.
5. Observe the following precautions whenever lubricating the machine or making adjustments.
•
Disengage all clutching levers or switches.
•
Lower the attachment, if equipped, to the ground or raise the attachment completely and engage the
cylinder safety locks. Completing these actions will prevent the attachment from lowering unexpectedly.
•
Engage the parking brake.
•
Shut off the engine and remove the key.
•
Wait for all machine movement to stop before leaving the operators platform.
6. Always keep the machine in gear while travelling downhill.
7. The machine should always be equipped with sufcient front or rear axle weight for safe operation.
8. Under some eld conditions, more weight may be required at the front or rear axle for adequate stability. This is
especially important when operating in hilly conditions or/when using heavy attachments.
9. Always lower the attachment, shut off the engine, set the parking brake, engage the transmission gears, remove
the key and wait for all machine movement to stop bef ore leaving the operators platform.
10. If the attachment or machine should become obstructed or plugged; set the parking brake, shut off the engine
and remove the key, engage the transmission gears, wait for all machine or attachment motion to come to a stop,
bef ore leaving the operators platform to removing the obstruction or plug.
11. Never disconnect or make any adjustments to the hydraulic system unless the machine and /or the attachment is
lowered to the ground or the safety lock(s) is in the engaged position.
12. Use of the ashing lights is highly recommended when operating on a public road.
13. When transporting on a road or highway, use accessory lights and devices for adequate warning to the opera-
tors of other vehicles. In this regard, check local government regulations. Various safety lights and devices are
available from your CASE IH AGRICULTURE dealer.
14. Practice safety 365 days a year.
15. Keep all your equipment in safe operating condition.
16. Keep all guards and safety devices in place.
17. Always set the parking brake, shut off the engine and remove the key, engage the transmission gears, wait for all
machine or attachment motion to come to a stop, before leaving the operators platform to service the machine
and attachment.
18. Remember: A careful operator is the best insurance against an accident.
19. Extreme care should be taken in keeping hands and clothing away from moving parts.
47506838 04/04/2013
7
To Next Page
Loading...
Need help?
General
