INTRODUCTION
Safety rules
AXIAL-FLOW 5130, AXIAL-FLOW 6130, AXIAL-FLOW 7130
All repair and maintenance works listed in this manual must be carried out only by qualied dealership personnel,
strictly complying with the instructions given; and using, whenever possible, the special tools.
Anyone who carries out the above operations without complying with the procedures shall be responsible for the
subsequent damages.
The manufacturer and all the organizations of it's distribut ion chain, including - without limitation - national, regional,
or local dealers, reject any responsibility for damages due to the anomalous behavior of parts and/or components not
approved by the manufacturer himself, including those used for the servicing or repair of the product manufactured
or marketed by the manufacturer. In any case, no warranty is given or attributed on the product manufactured or
marketed by the manufacturer in case of damages due to an anomalous behavior of parts and/or components not
approved by the manufacturer.
The information in this manual is up-to-date at the dat e of the publication. It is the policy of the manufacturer for
cont inuous improv ement. Some information could not be updated due to modicat ions of a technical or commercial
type, as well as to suit the laws and regulations of different countries.
In case of questions, refer to your Sales and Service Networks.
47506838 04/04/2013
8
To Next Page
Loading...
Need help?
General
