Case IH AXIAL-FLOW 6130 User Manual

INTRODUCTION
Basic instructions - Shop and Assembly
AXIAL-FLOW 5130, AXIAL-FLOW 6130, AXIAL-FLOW 7130
SHIMMING
For each adjustment operation, select adjusting shims and measure individually using a micrometer, then add up
the recorded values. Do not rely on measuring the entire shimming set, which may be incorrect, or the rated value
indicated on each shim.
ROTATING SHAFT SEALS
For correct rotat ing shaft seal installat ion, proceed as follows:
•
bef ore assembly, allow the seal to soak in the oil it will be sealing for at least thirty minutes.
•
thoroughly clean the shaft and check that the working surface on the shaft is not damaged.
•
position the sealing lip facing the uid; with hydrodynamic lips, take into consideration the shaft rotat ion direction
and position the grooves so that they will deviate the uid towards the inner side of the seal.
•
coat the sealing lip with a thin layer of lubricant (use oil rather than grease) and ll the gap between the sealing lip
and the dust lip on double lip seals with grease.
•
insert the seal in its seat and press down using a at punch or seal installation tool. Do not tap the seal with a
hammer or mallet.
•
whilst inserting the seal, check that it is perpendicular to the seat; once settled, make sure that it makes contact
with the thrust element, if required.
•
to prevent damaging the seal lip on the shaft, position a protective guard during installat ion operations.
O-RI NG SEALS
Lubricate the O-RING seals before inserting them in the seats, this will prevent them from overturning and twisting,
which would jeopardise sealing efciency.
SEALING COMPOUNDS
Apply one of the following sealing compounds on the mating surfaces when specied: SILMATE® RTV1473, or
L
OCTITE
® RTV 598 or L
OCTITE
® I
NS TANT
G
ASKE T
587 B
LUE
. Before applying the sealing compound, prepare the
surfaces as directed on product cont ainer or as follows:
•
remove any incrustations using a metal brush.
•
thoroughly de-grease the surfaces using a locally approved cleaning agent such as safety solvent or brake parts
cleaner.
SPARE PARTS
Only use "CNH Original Parts" or " CASE IH AGRICULTURE Parts".
Only genuine spare parts guarantee the same quality, duration and safety as original parts, as they are the same
parts that are assembled during standard production. Only "CNH Original Parts" or " CASE IH AGRICULTURE
Parts" can offer this guarantee.
When ordering spare parts, always provide the following information:
•
machine model (commercial name) and serial number
•
part number of the ordered part, which can be found in the "Microches" or the "Service Parts Catalogue", used for
order processing
47506838 04/04/2013
9

Case IH AXIAL-FLOW 6130 Specifications

General

Brand	Case IH
Model	AXIAL-FLOW 6130
Category	Farm Equipment
Language	English