22
operation
START THE GENERATOR RECOIL START
OPEN THE CHOKE VALVE
Start via the pull wire: Pull the wire gently to connect the disc to the
starting bowl inside the unit. Pull the wire out in an instant action and
the generator unit will be started after doing this twice. If it is not started
please conduct the above operation with the choke valve.
After starting, let the unit run without load for 5 seconds and then turn on
the choke valve switch.
WARNING
It may be causing the dangers of injury by the sudden change of rota-
tion direction of the engine during operating the recoil starter.
To Next Page
Loading...