15
generator components
SPARE PARTS LIST
Fuel Tank It is used to hold fuel, gasoline is allowed only.
Fuel Tank Cap
Screw the fuel injection port in use and do not
open it in equipment operation.
Fuel Gauge It is to indicate fuel level in the fuel tank.
AC Output
AC output socket provides the power supply.
Please refer to models parameter table for its
rated power. Load of each socket cannot exceed
its rated current and total power of electric device
cannot surpass rated power of the generator. Do
not start up several electric devices simultaneously,
but switch on another one after stable operation of
one electric device.
AC Circuit
Breaker
It will break to protect the electric device when
current is too heavy.
Output Indicator
It is to indicate power supply status. The indicate
will brighten up when the equipment operation.
DC Output
The output DC is 12V with maximum of 8.3A. It
is only used for automotive battery charging with
rated 12V. Pay attention to connecting the positive
and negative electrode correctly.
Engine Switch
It is to start up (applicable to electrical starting
only) and switch off the engine. Turn to the off
state in non use.
Wheel (optional) It is for moving the generator in a short time.
Battery
It is for starting up the generator. In case of non
use for three months, charge it.
Oil Filler Cap
It is for measurement of engine’s oil level. Make
sure engine’s oil level is between MIN and MAX in
the dipstick of oil filler cap before use. Oil can be
added after removing the oil filler cap,
Oil Drain Bolt
Unscrew this bolt when replacing the engine
oil. Drain out the old engine oil and dispose of it
properly according to local laws, avoiding damage
to the environment.
Foot It is to support the generator.
To Next Page
Loading...