SECTION 58 - DRIVELINES - CHAPTER 3
58-20
43
Assembly
Disc modules can be assembled for clockwise or
counter-clockwise rotation of the disc. Before
assembling a disc module it must be determined at
which cutter bar location the disc module will be used
to ensure it is assembled for proper rotation. When
looking at a disc module from the rear, a
counter-clockwise module will have the pinion gear
on the left side, and a clockwise module will have the
pinion gear on the right side.
The direction of rotation of an assembled module can
be determined by looking at the ends of the lower
module shaft; the pinion end of the shaft has a
shallow groove in the end to identify it.
NOTICE: The view in Figure 42 is from the rear of the
cutter bar.
To Next Page
Loading...
