SECTION 00 -- GENERAL INFORMATION -- CHAPTER 1
00-18
STORING THE MOWER
1. Clean the mower. Grease all fittings.
2. Drain the oil from the bevel gearbox and all
modules and refill with new, clean oil to the correct
level. Run the mower for a few minutes.
3. Store the cutter bar in the operating position.
4. Remove the drive belt and store it in a dry place.
5. Clean the cutter bar rusted area and touch up with
Case IH paint. Spray cans are available from your
Case IH dealer.
To Next Page
Loading...
