2000-6
ENGINE REMOVAL
Put identification tags
on
all disconnected hoses and
wires. Close disconnected hoses and fittings with
caps and plugs.
NOTE:
The
photos in this procedure may be
different from your machine and are for reference
only.
STEP 1
8D010042
Park the machine
on
a level surface. Raise the loader
and lock the support strut to hold the loader.
STEP2
BD00F122
Remove the battery cover from the right step. If the
machine
has
only
one
battery,
disconnect
the
negative battery cable from the battery.
Bur 6-43820
STEP3
BD00H122
If the machine has two batteries, remove the terminal
nuts
(1
). Remove
the
jumper
cable
(2) from
the
batteries. Remove the negative ground strap
(3)
from
the battery.
STEP4
Drain the oil from the hydraulic reservoir.
NOTE: During installation fill the hydraulic reservoir
with the oil specified in section 1002
of
this manual.
STEPS
If the machine
is
equipped with air conditioning. See
Section 9004 and recover the coolant from the air
conditioning system.
NOTE: During installation see Section 9004
and
recharge the air conditioning system.
STEP6
8D018356
Remove the bolts
(1
),
bumpers (2), and the grille
(3)
from the front of the machine.
Issued
6-01
Printed
in
U.S.A.
To Next Page
Loading...
