STEP7
8D018311
Remove the bolts, washers, and nuts from the pivot
point
on
the hood.
STEPS
8D018357
Do
the following procedure to remove the hood.
D.
Remove the retainers from the hood struts
(1)
and disconnect the hood struts from the stud.
E.
Disconnect the hood cable
(2)
from the
radiator shroud.
F.
Carefully lower the hood back to the closed
position.
Bur 6-43820
2000-7
STEP9
8D018311
Drive the pivot tubes out of the hood pivot point.
STEP10
Use acceptable lifting
equipment
and remove the
hood from the machine.
STEP11
,.
8D018322
Slowly remove the radiator cap. Install a hose
on
the
drain
valve
and
drain
the
radiator
into
a
clean
container that holds approximately 17 litres (18 U.S.
quarts).
NOTE: During installation, fill the radiator and
coolant reservoir completely with coolant. See
Section 1002 for coolant specifications. Start and run
the engine until the coolant
is
at
operating
temperature. Stop
the
engine and check for leakage.
When
the
coolant
is
cold, check the coolant reservoir
level. Add coolant as required.
Issued
6-01
Printed
in
U.S.A.
To Next Page
Loading...
