SECTION 35 - HYDRAULIC SYSTEM 51
Loosen and remove the three screws (3) and disas-
semble valve (4).
Check and eventually replace the O-rings (5).
In case of necessity it is possible to disassemble the
various solenoid valves from the manifold blocks.
Loosen and remove the screws (6).
Disassemble the solenoid valves (7).
Check and eventually replace the O-rings (8).
Loosen and remove the valve (9).
Check and eventually replace the O-rings (10).
Remove the check valve (11) and the orifice (12).
Loosen and remove the solenoid valves (13).
Check and eventually replace the O-rings (14).
Loosen and remove the solenoid valves (15).
Check and eventually replace the O-rings (16).
To Next Page
Loading...
