2000-8
STEP 29
BD06F121
Tag and remove the wires from the starter solenoid
(3), remove the ground cable (2), and ground strap
(1) from the starter.
NOTE: Move the starter cables away from the
engine, move the wiring harness away from the
engine.
STEP 30
BD06F146
Disconnect the engine coolant vent hose and root to
the rear of the engine.
STEP 31
BD06F122
Remove the radiator hose (1) from the rear of the
engine, remove the heater hose from the rear of the
engine (2), remove the clamp bolts and clamps (3)
from the bell housing.
STEP 32
BD06F111
Tag and remove the grid heater cable.
STEP 33
BD03A142
Disconnect the wiring harness from the EDC 7
controller.
NOTE: Lifting up on the lever will release the
connector from the controller.
STEP 34
BD06F123
Remove the fuel line from the top of the EDC 7
controller, plug the line and cap the fitting.
To Next Page
Loading...
