Case 821F Tier 4 - 821 F Performance Specifications; Performing Stall Tests

2002-3
821F SPECIFICATIONS
Engine with 4 Speed Transmission
A. Low idle ..........................................................................................................................................870 to 930 rpm
Alternate low idle .................................................................................................................................570 to 630 rpm
Alternate Accelerated Idle ...............................................................................................................1170 to 1230 rpm
B. Maximum No Load RPM .............................................................................................................2100 to 2155 rpm
C. Converter Stall ............................................................................................................................1883 to 1963 rpm
D. Hydraulic Stall .............................................................................................................................1883 to 1963 rpm
E. Converter & Hydraulic Stall .........................................................................................................1497 to 1577 rpm
Temperature of the torque converter oil.......................................................................82° to 104° C (180° to 220° F)
Temperature of the hydraulic oil.......................................................................................54° to 57°C (129° to 134°F)
Engine with 5 Speed Transmission
A. Low idle ..........................................................................................................................................870 to 930 rpm
Alternate low idle .................................................................................................................................570 to 630 rpm
Alternate Accelerated Idle ...............................................................................................................1170 to 1230 rpm
B. Maximum No Load RPM .............................................................................................................2100 to 2155 rpm
C. Converter Stall ............................................................................................................................1860 to 1900 rpm
D. Hydraulic Stall .............................................................................................................................1923 to 2003 rpm
E. Converter & Hydraulic Stall .........................................................................................................1524 to 1604 rpm
Temperature of the torque converter oil.......................................................................82° to 104° C (180° to 220° F)
Temperature of the hydraulic oil.......................................................................................54° to 57°C (129° to 134°F)
NOTE: Hydraulic Stall and Converter & Hydraulic Stall RPM values are read while the lift arms are rising with the
bucket held rolled back and the engine at WOT in max power mode with transmission in manual mode and in 3rd
gear.
STALL TESTS
During these tests the engine runs at full throttle and works against the torque converter, the hydraulic system, or
both the torque converter and the hydraulic system. The results of these tests will show if the cause of poor
performance is one or more of the following: (1) engine, (2) torque converter or transmission, and (3) hydraulic
system.