DIAGNOSTIC - SELECTION
4 - 21
CASE TRAINING CENTER
AUGUST 2000
CHANGING THE ACCESS CODE FOR THE ANTI-THEFT SYSTEM
A. Hood
A. Violet wire marked 469 female plug
B. Black wire marked 621 male plug
C. Radio connector
1. Remove the hood (A) located behind the operator’s seat.
2. Disconnect the two wires (A) (B) covering the anti-theft system.
3. Turn the starter key switch to ON and then OFF.
4. Reconnect the two wires (A) (B) covering the anti-theft system (see paragraph 2).
5. To save the new access code, consult the anti-theft protection section in the operator’s manual.
A
B
A
C
To Next Page
Loading...
