4 - 20
DIAGNOSTIC - SELECTION
CASE TRAINING CENTER
AUGUST 2000
Step 5
To finish entering the code, place the starter switch key in
“OFF” position.
IMPORTANT: Remember to keep careful note of the
code number, because if you forget it, it will not be
possible to enter a new one without consulting your
CASE Dealer.
Using the anti-theft device
The anti-theft device has to be actuated when you are
shutting down the engine. Turn the starter switch from
“ON” to “OFF”, “ON” to “OFF” for about 2 seconds at a
time until the audible alarm device sounds. The anti-theft
device is now operational and before being able start the
engine you will have to enter the access code.
You are not obliged to activate the anti-theft device. If you
so wish, when shutting down the engine, simply place the
starter switch key in the “OFF” position and it will not be
necessary to enter the access code to start the engine.
Entering the access code
If the anti-theft device was activated the last time the
engine was shut down, then it will be necessary to enter
the access code before being able start it again.
Step 1
Place the starter switch key in the “ON” position.
Step 2
The message “Password” and four boxes will appear on
the display screen.
Step 3
o enter the code (e.g. 1234), press button (1) the same
number of times as the digit selected (e.g once) then press
button (2) to proceed to the second digit. Press the button
(1) same number of times as the second digit (e.g. twice)
and then press button (2) to proceed to the third digit.
Repeat the procedure for the third and fourth digits.
1
2
To Next Page
Loading...
