22 SECTION 10 -- ENGINE -- CHAPTER 1
84176554 -- 03--2008
-- Refit the brake piping support and the two retain-
ing bolts.
-- Refit the condenser , air cooler and radiator
pipes.
-- Refit the dryer filter together with its support and
piping, tightening the two retaining bolts.
-- Refit the bonnet support, tightening the retaining
bolts.
-- Refit the support with the fuse--holder box on the
bonnet support, tightening the two retaining
bolts.
-- Refit the support together with the relays protect-
ing the system on the bonnet support, fitting the
two retaining bolts.
-- Refit the brake fluid reservoir onto the support
and the two retaining clips.
-- Refit the silencer together with the exhaust pipe.
-- Secure the silencer to the exhaust manifold with
the four nuts and connect the air filter dust ex-
tractor pipe to the silencer exhaust, inserting the
retaining clamp.
-- Refit the three rear retaining bolts of the exhaust
silencer.
-- Fit the cab heater delivery and return pipes and
insert the associated clamps.
-- Refit the fitting of the hose delivering power
steering oil to the hydraulic cylinders governing
the front wheel steering.
-- Install the flexible cables governing the hand and
pedal throttle, inserting the retaining clips.
-- Reconnect the throttle control tie--rod to the in-
jection pump, inserting the retaining clip.
-- Working from inside the cab, fit the four plugs to
gain access to the upper bolts securing the en-
gine, located at the base of the steering column.
-- Refit the pedal on the differential lock drive shaft,
the retaining pin and the footboard.
-- Refit the two right-- and left--hand dashboard
panels and the relevant four fixing knobs.
-- Refit the two power steering cylinder oil delivery
and return hoses.
-- Install the electrical connections between the
cab and the engine.
-- Reconnect the diesel delivery and return pipes to
the diesel pump and install the relevant plastic
fasteners.
-- Working on the left--hand side of the engine, in-
stall the lift pump draw pipe and tighten the re-
taining bolts.
-- Install the delivery pipe of the services pump on
the right--hand side of the engine and tighten its
fitting.
-- Refit the rigid pipe for drawing oil from the trans-
mission and the two metal clamps.
-- Refit the power steering/four--wheel drive drain
pipe on both the left-- and right--hand sides of the
engine.
-- Refit the lift pump draw pipe and lock the retain-
ing bolts.
-- Refit the propeller shaft with its central support
and the retaining bolts.
-- Refit the front axle drive shaft guard, tightening
the front, central and rear retaining bolts.
-- Refit the front ballast together with the support
and insert the retaining pin and the split pins.
-- Install the fitting of the cab heater radiator coolant
return pipe connected to the bottom of the cool-
ant pump and refill the engine coolant.
-- Refit the guard on the right--hand side of the fan,
tightening the three retaining bolts.
-- Refill the transmission--gearbox housing with oil.
-- Install the bonnet. Reconnect the battery nega-
tive lead.
To Next Page
Loading...
