Need help?Do you have a question about the Case JX80 and is the answer not in the manual?
General| Engine Power | 80 hp |
|---|---|
| Hydraulic System | Open Center |
| Type | Utility Tractor |
| Fuel | Diesel |
| Cylinders | 4 |
| Engine Type | Diesel |
| PTO Speed | 540 rpm |
| Fuel Capacity | 110 liters |
States work must be done by CASE IH technicians using specific tools.
Discusses liability for non-approved parts and guarantee limitations.
Details tools and troubleshooting for the F5C engine system.
Covers general specs, data, tools, lubrication, cooling, fault diagnosis for NEF engines.
Covers general specs, torque, tools, cross-sectional views, troubleshooting, and overhaul for clutches.
Details main data, torque, tools, operation, and fault diagnosis for 12x4 transmission.
Covers main data, torque, tools, operation, and fault diagnosis for 12x12 reverser.
Details main data, torque, tools, operation, and fault diagnosis for 20x12 reverser/creeper.
Main spec, torque, tools, cross-sectional views, shafts, and gear housing.
Main data, torque, tools, cross-sectional views, operation, removal/installation.
Main data, torque, special tools, cross-sectional views, operation, and troubleshooting.
Covers main spec, tools, torque, drawings, operation, troubleshooting, and overhaul.
Details main data, torque, cross-sectional views, operation, tools, troubleshooting, and specific brake procedures.
Covers main spec, torque, tools, views, operation, hydraulic circuit, and lift disassembly.
Main data, tools, sectional views, operation, fault diagnosis, assembly/disassembly.
Section views, operation, hydraulic diagram, and valve linkage adjustment.
Principal data, torque, section views, hydraulic diagram, operation, fault diagnosis, and tools.
Principal data for front axle and wheels.
Covers sectional views, torque, equipment, fault diagnosis, removal/refitting, and specific adjustments.
Covers general safety practices, personal protective equipment, and operating procedures.
Lists possible causes and solutions for an engine that fails to start.
Provides troubleshooting steps for an engine that stalls during operation.
Identifies causes and solutions for engine overheating.
Lists issues causing power loss and uneven running, with solutions.
Diagnoses and resolves abnormal knocking noises in the engine.
Addresses causes of excessive black, grey, or white smoke from the engine.
Troubleshoots why the engine continues to run after the switch is turned off.
Details initial steps like disconnecting battery, draining fluids, and removing exhaust.
Separating the engine from the transmission using the special tool.
Detaching the engine from the front axle, avoiding radiator damage.
To Next Page
