Case WX90 - Drive Machine Safely

SAFETY PRECAUTIONS
15501 9-35990
SR2-2-9
DRIVE MACHINE SAFELY
• Before starting the machine, carefully read this
manual (refer to the chapter OPERATING IN-
STRUCTIONS).
- Before moving the machine, confirm which way to
move travel pedals/levers for the corresponding
direction you wish to go.
- When traveling up or down a grade, keep the
bucket in the direction of travel, approximately 20
to 30 cm (A) above the ground.
- If the machine starts skidding or is unstable, lower
the bucket immediately.
- Cross-travelling on a slope can cause the machine
skidding or overturning. When travelling up or down
a slope, make sure the tyres are oriented in the
slope direction.
- Turning on an incline may cause the machine to
tip over. If turning on an incline is absolutely una-
voidable, do so at a place where the slope is gen-
tle and the surface is firm.
- Never go down on slopes with travel pedal in neu-
tral. You might loose control and cause serious in-
juries or death.
- When going down on slopes, use a low gear. In
this way the travel motor is used as brake and holds
the machine without overloading brakes.
- When working on a slope and the warning light
for fuel insufficient level lights up, fill the tank im-
mediately.
F5632
F5633
F7731
F7730
CORRECT
WRONG