Crown Operations
Q1
Nothing happens when I rotate the
crown.
If you do not perform any operation for about
two minutes after pulling out the crown
(approximately 30
minutes in the case of hand
and day indicator alignment), crown
operations will automatically become
disabled. Push the crown back in to its normal
position and then pull it out again to re-enable
crown operations.
l
Using the Crown
Q2
Crown operation does not work.
Crown operation is disabled while high-speed
hand movement is in progress after a watch
setting is changed, etc. Wait until the hands
stop moving before performing crown
operations.
Charging
Q1
The watch does not work even
though it is exposed to light.
The watch stops operating whenever the
battery goes dead. Keep the watch exposed
to light until it recharges sufficiently.
l
Solar Charging
Operation Guide 5512
20
To Previous Page
Loading...
Need help?
General
