Casio 5512 User Manual

Configuring Stopwatch
Settings
You can specify a target value for comparison
with lap times measured in the Stopwatch
Mode. You
can also enable or disable an alert
that sounds when your current lap time
matches the target value.
l
Checking the Difference between a Lap
Time and the Target Time
l
Split Times and Lap Times
●
Specifying the Target Value Type
You can specify one of the target values
described below, which are used to calculate
the difference
between your target and actual
lap time measurements.
FASTEST (Fastest) :
Your fastest lap time during the current
session is automatically set for this target
value. This
setting is refreshed each time your
achieve a new fastest lap. Resetting the
stopwatch to all zeros will also clear this target
value.
TARGET (Target) :
This is a fixed value that you specify using
CASIO WATCH+.
1.
Y Tap the “CASIO WATCH+
” icon.
2.
X
Hold down the (C) button for about 2
seconds.
●
This causes the second hand to move
to 12 o’clock. Keep (C) depressed at
this time until the second hand
completes one full rotation.
●
The
retrograde
dial hand will move from
“R” to e when a connection is
established between the watch and
phone.
3.
Y Perform the operation shown on the
phone screen to specify a target value
type.
Note
●
If you
specified TARGET (Target) as
the target value type, you should
also specify the target value.
l
Specifying the TARGET (Target)
Value
●
Changing the
target value type while
a stopwatch measurement
operation is stopped will reset the
stopwatch measurement value to all
zeros.
●
Specifying the TARGET (Target) Value
If you specified TARGET (Target) as the target
value type, perform the procedure below to
specify the target value.
●
The TARGET (Target) value setting cannot
be less than 15 seconds.
1.
Y Tap the “CASIO WATCH+
” icon.
2.
X Hold down the (C) button for about 2
seconds.
●
This causes the second hand to move
to 12 o’clock. Keep (C) depressed at
this time until the second hand
completes one full rotation.
●
The
retrograde
dial hand will move from
“R” to e when a connection is
established between the watch and
phone.
3.
Y Perform the operation shown on the
phone screen to specify the TARGET
(Target) value.
Note
●
Changing the TARGET (target)
value while a stopwatch
measurement operation is stopped
will reset the stopwatch
measurement value to all zeros.
●
Enabling or Disabling Alert Sounds
You can configure a setting so the watch
sounds a tone when the lap time reaches the
target value during measurement.
1.
Y Tap the
“CASIO WATCH+” icon.
2.
X
Hold down the (C) button for about 2
seconds.
●
This causes the second hand to move
to 12 o’clock. Keep (C) depressed at
this time until the second hand
completes one full rotation.
●
The
retrograde
dial hand will move from
“R” to e when a connection is
established between the watch and
phone.
3.
Y Perform the operation shown on the
phone screen
to enable or disable the alert
sound.
Note
●
Changing the alert sound setting
while a stopwatch measurement
operation is stopped will reset the
stopwatch measurement
value to all
zeros.
Operation Guide 5512
7

Casio 5512 Specifications

General

Brand	Casio
Model	5512
Category	Watch
Language	English