●
Alarm Mode
In this mode, the main hour and minute hands
indicate the current time in your current
location (Home City), while the dial hour and
minute hands show the alarm time setting.
30
③④⑤
①
②
Enabling/
Disabling
the Alarm
A
Mode
B
Alarm enable/disable
The second hand will point to “ON” while the
alarm is turned on, and to “OFF
”
while it is
turned off.
C
Alarm minute
D
Alarm hour
E
Alarm 24-hour hand
The A-side of the dial indicates an a.m. time,
while the P-side indicates a p.m. time.
Using the Crown
The watch’s crown is a screw-in (screw lock)
type. To
use the crown, you first need to rotate
it towards you (leftwards) to loosen it.
●
Pulling Out and Pushing In the Crown
To perform a crown operation, pull it out to the
first or second click and then rotate it. Do not
pull the crown with too much force.
First click
Second click
Important!
●
To prevent loss of water resistance
and/or damage due to impact, be
sure to
screw the crown in by rotating
it away from you as you push it in.
●
When pushing the crown back in,
take care not to apply too much
force.
●
Fast Forward/Fast Reverse
After pulling out the crown, rotating it quickly
in succession
in either direction will cause the
hands to move forward or back at high speed.
While the hands are moving forward at high
speed, quickly rotating the crown in
succession again will increase the speed even
further.
●
Stopping Fast Forward/Fast Reverse
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
●
If you do not perform any operation
for about two minutes after pulling
out the crown, crown operations will
automatically become disabled. If
that happens, push the crown back
in and then pull it out again.
Hands and the Day Indicator
Movement
●
Mode Hand and Day Indicator
Movement
Changing the day setting of the watch will also
cause the mode hand to move.
●
Day
●
It can take anywhere from about 15 to 30
seconds for
the day indicator to change after
timekeeping reaches midnight. The mode
hand moves as the day indicator changes.
●
The day indicator will not change while a
stopwatch time measurement operation is
in progress.
Solar Charging
This watch runs on power supplied from a
rechargeable (secondary) battery that is
charged by a solar panel. The solar panel is
integrated into the face of the watch, and
power is generated whenever the face is
exposed to light.
●
Charging the Watch
When you are not wearing the watch, put it in
a location where it is exposed to bright light.
While you are wearing the watch, make sure
that its face (solar panel) is not blocked from
the
light
by the sleeve of your clothing. Power
generation efficiency is reduced even when
the face of the watch is blocked only partially.
Important!
●
Depending on light intensity and
local conditions, the watch may
become hot to the touch when
exposed to light for charging. Take
care to avoid burn injury after
charging. Also, avoid charging the
watch under high-temperature
conditions like the ones described
below.
ー
On the dashboard of a vehicle
parked in the sun
ー
Near an
incandescent light bulb or
other source of heat
ー
Under direct sunlight or in other
hot areas for long periods
Operation Guide 5512
3
To Next Page
Loading...
Need help?
General
