Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, adjust hand alignment.
Adjusting Hand Alignment
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least five seconds.
Release the button when [H.SET] stops
flashing and [0:00] starts to flash.
This enables adjustment of the hour and
minute hands.
3. If the hour and minute hands are not at 12
o’clock, use (B) and (D) to align them.
4. Press (A) to complete the setting
operation.
Other Settings
This section explains other watch settings you
can configure.
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
3. Press (C) nine times.
This causes [KEY♪] or [MUTE] to flash on
the display.
4. Use (B) and (D) to select [KEY♪] or
[MUTE].
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone muted.
5. Press (A) to exit the setting screen.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
Note that alarm and timer tones will still
sound even while the operation tone is
muted.
Watch Operation Guide 5663
14
To Next Page
Loading...
Need help?
General
