Casio Casiotone CT-S500 - To Change Effect Parameter Settings

Applying the Effect You Want to a Tone (Active DSP)
EN-103
1. Press ACTIVE DSP.
This enables Active DSP and displays the Active DSP screen.
• This causes the ACTIVE DSP LED to light.
2. Press PARAMETER.
This displays the module selection screen.
• You can rotate the dial to change the part effect while this screen is displayed.
3. Press the button of the module whose parameters you want to change.
This displays the module parameter setting screen.
4. Use U and I to select the parameter you want to change.
5. Rotate the dial or use – and + to change the setting.
6. Press BACK to return to the module selection screen.
7. To exit the setting operation, press BACK.
• Bypass is a special parameter. Enabling it stops the effect from being applied to the module.
To change effect parameter settings